The 9DIN-S signal conditioner provides everything needed to operate all varieties of strain gage transducers and to deliver optimal signal output. The 9DIN-S Includes:

Isolation: The 9DIN-S is three way isolated. Galvanic isolation is present between the power supply, input, and output.
Transducer Flexibility: The 9DIN-S provides switch-selectable strain gage style. The 9DIN-S supports full, half, and quarter bridge strain gages with resistances from 120 ohms to 20,000 ohms. These choices allow the 9DIN-S to operate Load Cells, Torque Transducers, and Pressure Transducers in addition to quarter and half bridge strain gages. Transducers may be connected with a 3, 4, or 6 wire hookup.
Transducer Excitation: The 9DIN-S has an adjustable excitation that provides a highly stable, low noise Voltage. Current limiting is provided.
Transducer Amplification: For maximum resolution of measurement data, the 9DIN-S amplifies strain gage signals with a multi-stage differential amplifier. Thirteen input ranges from 0.1 to 1000 mV/V are available.
Transducer Filtering: The 9DIN-S filters and conditions strain gage signals with active low-pass filtering to eliminate unwanted signal noise. Filter cutoff is switch selectable at 30 Hz or 5000 Hz. Filters style is 4 pole Butterworth filters.
Output: The 9DIN-S has two outputs for optimal convenience. Outputs are provided for +/-10 Volt, and 4-20 mA operation.
Calibration: The 9DIN-S can be calibrated by using either an internal 5mV precision reference or a shunt resistor across one arm of the strain gage bridge.
Alarms: An over Voltage alarm alerts the user to any signals exceeding the recommended output rating. An alarm LED lights whenever the signal is outside the +/- 10 Volt limits of operation.
Mounting: The 9DIN-S mounts to a standard DIN-EN mounting rail.

• Strain Gage Signal Conditioning
• Full, Half or Quarter Bridge Gages
• 120 ohms to 20,000 ohms Bridge Resistance
• 1.25-12 Volt Excitation
• 0.1% FS Accuracy
• 1000 Volts Isolation (Three Way)
• Multiple Outputs (+/-10Volt, 4-20mA)
• 13 Bit Resolution
• Voltage or Shunt Calibration Options

Sensors Supported